Stratasys K6 Series User Manual page 167

D. Refer to Table 5-4
Table 5-4: Model Tip Slice Heights
E. If the value measured in
(see Table 5-4) the printer is calibrated for the Z axis and an adjustment is not required.
Proceed to step 21.
F. If the value measured in
height (see Table
buttons within the Adjust XYZ Calibration page. Each button press equates to one ten
thousandths of an inch.
• Use the Down button to enter the value obtained in
height. For example, if you measured an average of 0.008 in.
(0.203 mm) for a tip with a slice height of 0.010 in. (0.254 mm), press the Down button until
0.0080 (0.203) is displayed within the Material Thickness field.
Figure 5-16: Z Offset Adjustment
English units
and determine the slice height for the model tip installed in your printer.
Model Tip Slice Height (in)
T10
T12
T16
T20
T20C
step C is within ±0.0005 in. (0.01 mm) of the model tip's slice height
step C is not within ±0.0005 in. (0.01 mm) of the model tip's slice
5-4), you will need to enter a Z offset adjustment using the Up and Down
Slice Height (mm)
0.005 0.127
0.007 0.178
0.010 0.254
0.013 0.330
0.010 0.254
step C
Down button
for adjusting Z
offset
158
if this value is less than the tip's slice
Metric units