Stratasys K6 Series User Manual page 142

6. Verify that the material and tip selections displayed are correct. If you need to change your
material and/or support tip selections, press the Previous button and make changes as needed.
Ensure that a part is not on the platen and then press the Next button to proceed with the wizard.
A screen will be displayed briefly informing you that the platen is moving to the oven cleaning
location.
Caution: Pressing the Next button will instruct the platen to move to the oven
cleaning location; the platen will raise upward to the top of the oven. If a part is
left on the platen it can get smashed or damaged during this process, and
potentially cause damage to the printer. Always remove parts from the platen
when instructed.
133