Touchscreen User Interface; Emergency Stop - Stratasys K6 Series User Manual

RIGHT & LEFT SIDE PANELS
Warning: The right and left upper and lower side panels should only be removed
by an authorized service representative.
UPPER & LOWER REAR PANELS
Warning: The upper and lower rear panels should only be removed by an
authorized service representative.
Removal of the lower rear panel will cause the printer to immediately power OFF.

TOUCHSCREEN USER INTERFACE

Allows for user control of the printer. From the User Interface you can access various screens to select jobs for
building, control jobs in the process of being built, change materials and tips, perform calibrations, and configure
your printer's settings and maintenance options. The touchscreen visually displays the operational state of the
printer as well as any warning information available.
See "4 User Interface" on page 4-46
Interface.

EMERGENCY STOP

The Emergency stop (E-stop) button is a safety mechanism used to shut off the printer in an emergency
situation in which it cannot be powered down in the usual manner.
Pressing the E-stop button inward immediately removes power to the printer. This button should be used only as
an extreme measure to remove power to the printer. To reset the E-stop twist the E-stop button clockwise, doing
so will automatically revert the button to its original position. Once complete, follow the procedure for powering
the printer ON in order to restart the printer (see
for detailed information on the components and pages of the User
"Powering ON the Printer" on page 116
25
for instructions).