Licensing The Printer - Stratasys K6 Series User Manual

4. The Change 380mc Date and Time dialog will be displayed. The date and time settings within
this dialog are automatically configured based on the workstation PC's date and time settings.
Adjust the date and/or time setting if needed, then click OK to close the dialog. Your printer's
5.
date and time settings will be configured and are displayed within the Information Bar portion of
the User Interface (see
Figure 2-10:

LICENSING THE PRINTER

The printer must be licensed before it can be used to build parts. The process of licensing the printer involves
putting the printer into a mode which allows for material license upgrades, and then installing the printer's
material license file. This file contains the details of the printer's materials configuration (see
for details) and determines which model and support materials can be used to build parts on the printer. The
printer should have been licensed as part of its initial installation and setup (performed by your authorized
service representative). However, if after installing and loading material canisters your printer does not
recognize these canisters and will not allow you to initiate a build, you may need to license the printer. Follow
the steps within "Install/Update Material License" on page 215
"Information Bar" on page
Change Date and Time Dialog
47).
to license your printer.
22
Available Materials