Table of Contents
Advertisement
FDM CONTROL CENTER SOFTWARE
FDM Control Center is an application that connects with Insight software to send jobs to the printer to be built.
Control Center is designed to be used with your network-based Stratasys printer. Insight performs the model
processing to prepare a CMB file and Control Center connects to the printer to build the job and monitor the
printer's status.
Note: For detailed information about using FDM Control Center, see the
associated Help file within the application (available by selecting the Help option
within the Control Center toolbar).
Control Center software is packaged together with Insight software, and is installed on your workstation PC as
part of the initial installation and setup process (performed by your authorized service representative). During
the software installation process, your printer's network information should have been configured within Control
Center allowing you to send CMB files to the printer. If you find that you are unable to select your 380mc from
the drop-down menu within Control Center, you will need to add your modeler (printer) to your list of available
FDM systems, see
"Add Printer to Control Center" on page 212
for instructions.
45
Advertisement
Table of Contents
