Table of Contents
Advertisement
Figure 5-23:
Part Placement Dialog
7.
"Heating Oven and Tips" is displayed within the Information Bar. The oven will begin to heat to a
set point temperature determined by the material types specified for the job. Please be patient.
8.
After the oven and liquefier tips reach temperature "Finding Z Zero" is displayed within the
Information Bar, and the printer performs a Z Zero Calibration.
9.
Once Z Zero Calibration is complete the printer begins building the job. "Starting Part Build" is
momentarily displayed within the Information Bar. "Building" is displayed within the Information
Bar as the part is being built, and build progress is displayed within the Build page (see
"Information Available During a Build" on page
10.
When finished, "Build Complete - Remove Part" is displayed within the Information Bar indicating
that the completed part can be removed from the printer (see
page
173).
169).
"After a Build is Complete" on
168
Advertisement
Table of Contents
