Table of Contents
Advertisement
10.
Confirm that the material and tip selections displayed are correct and then press the Next button
to proceed with the wizard.
Note: Please be aware of the warnings associated with your selections. A tip
and/or material type change will require calibration. If you proceed past this
page of the wizard and exit the wizard without performing an XYZ Tip Offset
Calibration, your printer will not be calibrated. You will not be able to build parts
until you calibrate the printer by performing an XYZ Tip Offset Calibration.
Note: If the printer's head is not currently in the Service Location, a screen will
be displayed briefly informing you that the head is moving to the Service
Location.
139
Advertisement
Table of Contents
