14.
Reinstall the support side flicker/brush assembly by placing the assembly onto its locating pins
and sliding the assembly downward.
15.
Repeat
step 14
to reinstall the model side flicker/brush assembly.
16.
Reinstall the support side purge ledge by placing the purge ledge onto its locating pin and sliding
the purge ledge downward.
17.
Repeat
step 16
to reinstall the model side purge ledge.
18.
Reinstall the purge chute access plate and secure using the two thumbscrews.
19.
Adjust tip wipe assembly heights to ensure proper placement. See
on page 164
for instructions.
"Adjusting Tip Wipe Heights"
236