Stratasys K6 Series User Manual page 204

5. A screen will be displayed allowing you to select the calibration part's location on the build sheet
prior to starting the build. The screen contains a graphic representing your printer's platen as well
as a blue bounding box graphic (the imaginary box surrounding the part). Select the calibration
part's build location by dragging and dropping the bounding box on the touchscreen; the
bounding box cannot be placed outside the limits of the platen. Press the Next button to proceed
with the wizard.
Note: The Select Calibration Part Location page is displayed regardless of your
printer's Enable Part Placement setting configuration (see
Placement" on page 87
Figure 6-5: Select Calibration Part Location Page
Note: A build start delay of the first calibration job using Nylon 12 CF material is
normal. This period can be ~10 minutes while the oven stabilizes to a lower oven
temperature. Subsequent calibration jobs will begin in the normal timespan.
for details).
195
"Enable Part