Stratasys K6 Series User Manual page 60

Icon State
Flashing Red
TIP STATUS ICONS
The Dashboard contains two icons which represent the printer's model and support tips. Each icon displays the
tip's size (e.g. T10) and current odometer value (e.g. 58.3 in
Icons will appear in the following states (color usage and descriptions apply to both icons):
Table 4-3: Tip Status Icons - Icon States
Icon State
Blue (no white
highlighted border)
Blue (white highlighted
Description
Valid canister installed in canister bay, but material does not match the
current material configuration of the printer and/or the material currently
loaded to the head.
User action required to replace mismatched material or an existing
build will pause once the currently loaded canister empties. See
"Changing Tips or Material Type" on page 128
Yellow
Mismatched materials will not prevent you from starting a build. Upon
initiation of the build you will be warned of the material mismatch, and if
you choose to continue with the build, the mismatched materials will be
used to print the selected job.
Invalid or unreadable canister present in bay - user action required to
remove canister.
See "Unloading Material from the Liquefier Tips" on page 123
"Removing Canisters" on page 125
Description
Valid tip, tip size, and current odometer for this tip is displayed.
Tip is below odometer limit for associated material.
Valid tip, tip size, and current odometer for this tip is displayed.
Tip is below odometer limit for associated material and is currently in
position to be used for building.
While building, highlighting will switch between the model and support
icon to indicate which tip is currently active.
border)
Valid tip, tip size, and current odometer for this tip is displayed.
Tip is within 10% of or has reached the odometer limit for the
associated material (see
life information).
Yellow
Printer is still able to build with this tip, but you will be warned before
starting a build that the tip's odometer limit has been reached and part
quality may be negatively affected. User action is required to replace
tip. See "Changing Tips or Material Type" on page 128
for instructions.
for instructions.
3 3
/955.4 cm ). The model and support Tip Status
Table 3-4 on page 42
51
and
for approximate tip
for instructions.