Table of Contents
Advertisement
Warnings and Errors
Invalid material
•
Indicates that the installed material is not licensed for use with the printer.
•
Correct condition - to adjust your printer's material license please contact Stratasys
Customer Support or your regional Stratasys office (see
contact information).
Cannot load model in to support head
•
Indicates that you have inserted a model material coil box's filament key into the wrong
filament port in the printer.
•
Correct condition - Remove the material key from its current location and insert it into the
upper filament port. See
Cannot load support in to model head
•
Indicates that you have installed a support material coil box's filament key into the wrong
filament port in the printer.
•
Correct condition - Remove the material key from its current location and insert it into the
lower filament port. See
Cannot change material type during build
•
Indicates that the printer is currently in the process of building and you are attempting to
change model or support material during the build.
•
Correct condition - you cannot change material types while the printer is in the process of
building a part. Wait until the build is complete before changing materials.
Build Pause Warnings
User requested
•
Indicates that a pause was initiated by the operator or inserted within the job's file.
•
Correct condition - resume the build by pressing the Play button within the Build page (see
Table 3 (page 45)
Out of model material
•
The printer has run out of model material.
•
Correct condition - disconnect the empty material coil box and replace as needed. See
"Unloading Material" (page 105)
for instructions.
Out of support material
•
The printer has run out of support material.
•
Correct condition - disconnect the empty material coil box and replace as needed. See
"Unloading Material" (page 105)
for instructions.
Figure 11 (page 27)
Figure 11 (page 27)
Any pause not initiated by the operator will display a warning which must be
acknowledged on the User Interface before the printer can resume building.
for button details).
© Copyright 2020 Stratasys. All rights reserved.
for details.
for details.
and
"Connecting Material Coil Box To Printer" (page 98)
and
"Connecting Material Coil Box To Printer" (page 98)
Build Pause Warnings
"Getting Help" (page 192)
for
Page 198
Advertisement
Table of Contents
