Configuring The Network - Stratasys K6 Series User Manual

Figure 2-7: Rear Connections

CONFIGURING THE NETWORK

This section is provided in case you need to change your network settings.
The printer's network address type can be set to DHCP (Dynamic) or Static.
• DHCP (Dynamic) address - a network server or PC will generate an IP address for the printer. A
different IP address may be generated from time to time by the server or PC.
• Static address - you must enter an IP address, network mask, and gateway address for the printer
(provided by the system administrator). Once entered, the address will not change.
In addition to configuring the IP address, you can set the UPnP configuration for the printer.
• UPnP On - the printer will broadcast its Unique Device Name (UDN) address across the network.
This allows Insight software to automatically detect the IP address of the printer for communication.
• UPnP Off - the printer will not broadcast its IP address across the network. Insight software will need
to be manually configured to communicate with the printer.
18
AC Disconnect
Lever
Lockout Bar
Power Cable
Connection
AC Circuit
Breaker (OFF
Position)
Ethernet Network
Connection (RJ45)
Optional UPS
Connection