DOOR LOCKS
Sensors are used to communicate the status of the oven door and the top cover to the printer. For safety
reasons, the oven door and top cover must be closed before the X, Y, and Z motors will operate.
Electromagnetic locks ensure that the oven door and top cover remain securely closed when the printer is
building.
GENERAL SAFETY PRACTICES
Abide by these general safety practices when working with this printer.
High Voltage: High voltage is present in the printer.
Warning: Only use an OSHA or CE approved step stool when accessing the
area under the top cover of the printer.
Warning: Always wear safety gloves and long sleeves when working in the
oven, with the head, or liquefier tips. These components are very hot.
ENVIRONMENTAL REQUIREMENTS
•
The 380mc is for indoor use only.
•
Air quality conditions with excessive solid particulates (conductive or non-conductive) may
result in system damage.
•
Air quality conditions in which airborne oils are allowed to accumulate on or within the printer
can damage the plastic components.
•
Operating temperature shall be in the range of 65°F to 86°F (18°C to 30°C), with relative
humidity range of 30% to 70% non-condensing.
•
Storage temperature shall be in the range of -40°F to 129.2°F (-40°C to 54°C), with relative
humidity range of 10% to 85% non-condensing.
•
Altitude shall not exceed 6561.68 feet (2000 m).
•
Material storage shall be in the range of 55°F to 75°F (13°C to 24°C), with relative humidity
range of 20% to 50%.
10