AFTER A BUILD IS COMPLETE
After the completion of a build, the printer performs the following actions:
•
The Z stage is lowered and the head is parked.
•
Depending on your printer's auto cooldown configuration, the oven may or may not begin to cool
(see
"Auto Cooldown" on page 89
•
"Build Complete - Remove Part" is displayed within the Information Bar.
•
The Build Status Display graphic shows the build's percentage of completion as 100% and the outer
progress ring is completely filled (see
•
The Build State button turns yellow indicating a warning. Pressing this button will display a dialog
prompting you to remove the finished part
Note: If the build was terminated abnormally, press the Build State button to
view the reason(s) for the termination. See
for a list of abort related warnings/errors and resolution instructions.
Figure 5-27:
Remove Part Dialog
for details).
"Build Status Display" on page
.
(Figure
5-27)
"Build Abort Warnings" on page 251
173
57).