Figure 5-20:
Tip Installation
6.
Repeat steps
3
-
5
7.
Remove the head from the head maintenance bracket and return head to its initial position.
Secure the head to the head mounting plate using the two (2) recessed head mount fasteners.
Refer to
"Head Maintenance Bracket" on page 36
8.
Close the top cover.
Note: Make sure the filament tubes, umbilical cable, and air hose are not
tangled and are routed correctly.
9.
After changing one or both tips, you must manually adjust tip wipe heights to ensure proper
placement of the printer's flicker/brush assemblies in relation to tips/tip shields. Adjust tip wipe
heights as needed, see
if an additional tip needs to be changed.
"Adjusting Tip Wipe Heights" on page 164
for instructions.
for instructions.
163
Tip should be flush with
bottom of heater block