Stratasys K6 Series User Manual page 88

GO TO PURGE POSITION
Pressing the Go to Purge Position button will instruct the head to move to the purge position (directly above the
purge ledge). This button must be pressed before the Wipe Tips button will become selectable, as the head
must be in the purge position before tips can be wiped.
WIPE TIPS
After pressing the Go to Purge Position button the Wipe Tips button becomes selectable. Pressing the Wipe
Tips button will initiate a tip wipe. After pressing this button the head will begin to move back and forth, slowly
passing the model and support tips over the flicker/brush assemblies. The head will make 4 passes. With each
pass, the head gradually moves horizontally across the flicker to ensure proper adjustment and even wear.
You will need to access this button when adjusting tip wipe heights using the Tip Wipe Height Adjustment
Wheels, see "Adjusting Tip Wipe Heights" on page 164
Note: You must manually adjust tip wipe heights each time you change a tip.
This will ensure proper placement of the flicker/brush assemblies in relation to
tips/tip shields.
for instructions.
79