Table of Contents
Advertisement
MATERIALS
The Materials row displays the printer's materials configuration information (see
This information is based on the material license purchased for the printer. The printer's material license
determines the types of materials (model and support) that can be used to build parts on the printer. The printer
is licensed as part of its initial installation and setup process (performed by your authorized service
representative).
Pressing the right arrow graphic within the Materials row will open the Materials Details page.
Figure 4-90:
Figure 4-91:
The Materials Details page displays a list of the material types configured for use on the printer, and allows you
to put the printer into License Upgrade Mode. Pressing the Add License button within this page will open a new
page and put the printer into License Upgrade Mode. To close this page and return to the Maintenance page,
press the Maintenance button within the header of the page.
Note: The procedure for adding the license for MTConnect is the same as the procedure for
materials, described below.
Figure 4-92:
380mc Materials
380mc Carbon Fiber Edition Materials
Nylon 12 Carbon Fiber / ASA
Materials Details Page
113
Available Materials
for details).
Advertisement
Table of Contents
