Table of Contents
Advertisement
Note: As needed, press the Wipe Tips button again to initiate an additional 4
passes of the head.
6.
Once you believe you have achieved proper placement (as shown in
Wipe Tips button and observe placement via the purge chute access plate window. When
properly adjusted:
•
The tip's opening should slightly graze the top edge of the flicker. The flicker should not have any
contact with the tip shield.
•
If placement is too high, extreme resistance will occur when the tip passes over the flicker, which
may cause damage to the flicker/brush assembly.
Figure 5-22:
Proper Tip Wipe Placement
7.
If additional adjustments are needed readjust height using the Tip Wipe Height Adjustment
Wheels. When finished, close the canister bay doors.
165
Figure
5-22), press the
Advertisement
Table of Contents
