Table of Contents
Advertisement
AS NEEDED MAINTENANCE
REPLACE AN OVEN BULB
Hot Surface: Bulbs are hot; never touch bulbs with your bare hands. Always
wear safety gloves (provided in the Welcome Kit) when changing bulbs.
It is recommended that bulbs be removed/replaced when the printer is powered
OFF.
There are four festoon bulbs mounted on the front upper edge of the oven, two per side, which illuminate the
oven. Bulbs will periodically burn out and require replacement. Bulbs generally will burn out in pairs. Use the
following steps to replace an oven bulb:
1.
With the oven light turned ON, take note of which bulb needs to be replaced.
2.
Turn the oven light OFF using the
3.
Open the oven door. Ensure that you are wearing safety gloves and remove the burnt out bulb by
gently pulling it out of the clamps securing it to the edge of the oven.
Figure 7-32:
4.
Install a replacement bulb by gently pressing it into place within the securing clamps.
Note: Replacement bulb kits are supplied in the Welcome Kit. Once these
replacements are depleted you will need to order additional replacement bulb
kits.
5.
Repeat
step 3
door.
6.
Verify that the new bulb is operating by turning the oven light on using the
Button.
Oven Light Control Button
Bulb Locations
and
step 4
if additional bulbs need to be replaced. When finished close the oven
within the Dashboard.
238
Oven Light Control
Advertisement
Table of Contents
