VACUUM STATUS
The Vacuum Status row displays status information pertaining to the printer's vacuum system. "Low" is
displayed if vacuum pressure is below threshold. In this instance, a build sheet will not affix to the platen as
sufficient pressure is not present to hold the build sheet to the platen's surface. "Good" is displayed when
sufficient vacuum pressure is present. In this instance, a build sheet should affix to the platen within 5 minutes of
installation.
Figure 4-70:
DRYER STATUS
The Dryer Status row displays status information pertaining to the printer's dryer system. "Low" is displayed
when the pressure in the dryer system (determined by a sensor near the compressor) is below threshold.
"Good" is displayed when sufficient dryer pressure is present. During normal printer operation "Good" should
always be displayed.
Figure 4-71:
Vacuum Status
Dryer Status
104