MOTO GUZZI V100 E5 2023 Service Station Manual page 9

V100 E5
TRADITIONAL BATTERY ACTIVATION PRO-
CEDURE
•
Place the battery on a flat surface.
•
Remove the cell's protective sticker.
•
Take the acid container.
•
Remove the cap 1 of the container 2.
•
Place the container upside down, per-
pendicularly above the battery, align-
ing the outlets with the battery cells.
•
Apply pressure to the container to
break the seals. The liquid will begin to
flow into the cells.
•
Check that air bubbles come out of the
cells; let the liquid flow into the cells for
at least 20 minutes.
•
If no air bubbles escape and the liquid
does not flow, tap lightly on the bottom
of the container until the liquid begins
to flow into the cells. Never remove the
container from the battery, pierce it or
cut it to facilitate the exit of the liquid.
•
Make sure the liquid container is com-
pletely empty before removing it.
•
Allow the battery to stand for at least 1
hour, before starting the charging proc-
ess, without closing the six cells. This
operation is extremely important in or-
der to have the best battery perform-
ance over time.
•
Recharge the battery following the
specifications indicated on the battery
(see photo ) and using a suitable bat-
tery charger.
NOTE
IN THE SHOWN EXAMPLE IT IS IMPORTANT TO USE A
BATTERY CHARGER WITH 1.2 AMPERE (CHARGING TIME
5-10 HOURS) OR 5 AMPERE (CHARGING TIME 1 HOUR).
Pre-delivery
PRE DE - 9