MOTO GUZZI V100 E5 2023 Service Station Manual page 303

V100 E5
NOTE
THE FOLLOWING OPERATIONS REFER TO ONE FRONT BRAKE CALLIPER ONLY, BUT ARE
VALID FOR BOTH. THE VEHICLE MUST BE ON LEVEL GROUND TO BE BLED. WHILE PURGING
THE HYDRAULIC SYSTEM, FILL THE RESERVOIR WITH THE NECESSARY QUANTITY OF
BRAKE FLUID. CHECK THAT, DURING THE OPERATION, THERE IS ALWAYS BRAKE FLUID IN
THE RESERVOIR.
•
Unscrew the two screws (1) and re-
move the cap (2).
•
Remove the protective rubber (3).
•
Refill the tank with brake fluid.
CAUTION
DURING BLEEDING OPERATIONS, CONSTANTLY TOP UP
THE TANK SO THAT IT NEVER RUNS EMPTY. OTHERWISE
AIR WILL ENTER THE CIRCUIT AND THE BLEEDING OP-
ERATION WILL HAVE TO BE STARTED ALL OVER AGAIN.
•
Remove the rubber cap from the bleed
valve.
Braking system
BRAK SYS - 303