MOTO GUZZI V100 E5 2023 Service Station Manual page 209

V100 E5
•
Position the ring nut on the preload
spring and keeping it compressed,
screw the lock nut on the pumping el-
ement
•
Tighten the nut as much as possible.
•
Insert the cover and tighten until it
stops.
•
Using the special Ohlins tool, tighten
the cap to the prescribed torque.
Upper steering yoke
Removal
•
Unscrew the four fixing screws (1) and
remove the U-bolt (2) of the handlebar.
During refitting, first tighten the front fixing screws
and then the rear, all to the prescribed torque.
Locking torques (N*m)
Handlebar fixing screw
25 Nm (14.44 lbf ft)
Suspensions
SUSP - 209