MOTO GUZZI V100 E5 2023 Service Station Manual page 293

V100 E5
•
Insert the special screw (2) in the brake
pipe couplings using new sealing
washers (3).
•
Install the screw / joints assembly on
the brake calliper and tighten the spe-
cial screw (2).
•
Remove the clamp from the front brake lever.
•
Remove the brake fluid reservoir cap and fill it with new brake fluid
CAUTION
PERFORM THE STANDARD BRAKING SYSTEM BLEEDING PROCEDURE, AS DESCRIBED AT
THE END OF THE CHAPTER.
•
Top up the fluid reservoir and refit the cap
•
Check the stroke and sensitivity of the brake lever
•
If, after bleeding, the lever stroke is too long, check that there are no leaks in the braking
system. If there are no leaks, proceed with bleeding operations using the diagnostic tool.
•
Detach the hoses and tighten the bleed screws.
Rear brake disc
Braking system
BRAK SYS - 293