Suspensions
•
Place the handlebar on the tank. To
avoid damage to the bodywork, place
a protective cloth on the tank before
placing the handlebar.
•
Loosen the screw (3) of the steering
plate, on both sides.
During refitting, tighten the screws to the prescri-
bed torque.
Locking torques (N*m)
Upper steering plate screw
lbf ft)
•
Remove the plug (4) of the steering
plate.
During refitting, tighten the plug to the prescribed
torque.
Locking torques (N*m)
Upper steering plate plug
•
Remove the steering plate from the ve-
hicle.
NOTE
For the "MANDELLO S" version, before removing the up-
per steering plate, it is necessary to disconnect the wiring
harnesses from the forks.
Steering bottom yoke
SUSP - 210
25 ± 2.5 Nm (18.44 ± 1.84
100 Nm (73,76 lbf ft)
V100 E5