MOTO GUZZI V100 E5 2023 Service Station Manual page 142

Electrical system
Electrical specifications:
•
Primary circuit resistance (pin 1 and 3):
650 ± 50 mohm
•
Secondary circuit resistance: 4 ± 0.5
Kohm
Right coil pin out (1):
1. Power supply (+Vbatt)
2. Secondary circuit ground connection
3. Activation from the 11MP control unit
Left coil pin out (2):
1. Power supply (+Vbatt)
2. Secondary circuit ground connection
3. Activation from the 11MP control unit
Key:
1. Right cylinder coil.
2. Left cylinder coil.
3. 11MP ECU
4. Injection relay.
5. Fuse.
6. Battery.
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING,
CAREFULLY READ THE GENERAL TROUBLESHOOTING
CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGIN-
NING OF THE CHECK AND CONTROL SECTION IN THE
ELECTRICAL SYSTEM CHAPTER.
Throttle body
Function
To send the throttle position to the injection control
unit and to activate the throttle itself based on the
request from the control unit
Operation / Operating principle
All the unit internal components (potentiometer
and electric motor) are contactless; therefore, no
electrical diagnostic is possible for the throttle
body, but for the circuits connected to it only.
Level in electrical circuit diagram:
ELE SYS - 142
V100 E5