MOTO GUZZI V100 E5 2023 Service Station Manual page 120

Electrical system
Removal
•
Remove the driver's seat and battery
beforehand.
•
Lift the slide (1) and disconnect the
connector (2).
•
Lift the slide (3) and disconnect the
connector (4).
•
Remove the ECU (5) by pulling it up-
wards.
NOTE
WHEN REASSEMBLING THE CONNECTORS, THE SLIDES MUST SLIDE FREELY UP TO THE
LIMIT STOP, THUS FACILITATING THE CONNECTOR'S INSERTION: THE CATCH SHOULD SNAP
INTO PLACE ONCE THE LIMIT STOP IS REACHED.
NOTE
If the 11MP control unit is replaced, it will self-adapt to the vehicle parameters. During the first
tens of kilometres of vehicle use, the control unit will learn the parameters necessary for the
regular operation of the engine and the vehicle itself.
CONTROL UNIT - Diagnosis
Function
It manages the Ride by wire system, the injection/ignition, the system safety checks and the self-diag-
nostic function
Level in electrical circuit diagram:
Each level in which the main component involves the control unit
Position:
ELE SYS - 120
V100 E5