MOTO GUZZI V100 E5 2023 Service Station Manual page 294

Braking system
Removal
•
First remove the rear wheel.
•
Remove the two screws (1) fastening
the rear brake calliper.
During refitting, tighten the fixing screws to the
prescribed torque.
Locking torques (N*m)
Rear brake calliper fixing screw
3.69 lbf ft)
•
Remove the brake calliper from the
swingarm and fasten it to the vehicle,
so as not tighten the oil pipe and the
wiring harness of the ABS sensor.
•
Remove the rear brake disc together
with the flange from the rear wheel hub.
•
Unscrew the fixing screws (2) and re-
move the brake disc (3) from the sup-
port flange (4).
WHEN REFITTING, MAKE SURE THAT THE MARKINGS ON
THE BRAKE DISC ARE FACING UPWARD.
Disc Inspection
REAR
CAUTION
BRAK SYS - 294
50 ± 5 Nm (36.88 ±
V100 E5