MOTO GUZZI V100 E5 2023 Service Station Manual page 235

V100 E5
•
When required by P.A.D.S., deflate the front tyre, until the learning is complete.
WARNING
THE DEFLATION / LEARNING OPERATION MUST BE PERFORMED WITHIN A MAXIMUM 90
SECONDS.
CAUTION
TO BE ABLE TO PERFORM THE CALIBRATION, THE SENSOR MUST DETECT A DECREASE IN
TYRE INFLATION PRESSURE.
ONCE THE LEARNING IS COMPLETE, THE TYRE PRESSURE MUST BE BROUGHT BACK TO
THE NOMINAL VALUE. EVEN IF THE INITIAL PRESSURE IS ABOVE THE VALUE, IT WILL STILL
BE REQUIRED TO ADJUST THE INFLATION PRESSURE TO THE CORRECT VALUE.
•
Repeat the learning operations for the rear wheel also, selecting "Rear wheel TPMS learn-
ing".
•
After both learning procedures have been performed, wait a few minutes for the sensors to
align with the vehicle ECU. Any errors present will pass to the "STORED" status and can
be cancelled.
•
The current tyre pressure and temperature data will be displayed by selecting the "PARAM-
ETERS AND STATUS" tab.
CAUTION
If the pressure is 5.10 bar and temperature is 205 °C, it means that the sensor is not calibrated.
If a condition of this type occurs, it is necessary to carry out the TPMS learning procedure again.
Chassis
CHAS - 235