V100 E5
•
Occurs, when the transponder is working, but it is not within the recognised ones.
Identification
•
General alarm warning continuously on (red) and indication "ALARM IMMO B0003" on the
display
Troubleshooting
•
Store the new key
Error code B0004 (ALARM IMMO B0004)
Error cause
•
Occurs, when the key has no transponder or the transponder is damaged
Identification
•
General alarm warning continuously on (red) and indication "ALARM IMMO B0004" on the
display
Troubleshooting
•
Replace the key and store it
Error code B0005 (ALARM IMMO B0005)
Error cause
•
Occurs when an electric interruption or a ground short circuit or voltage to the circuit have
been detected.
Identification
•
General alarm warning continuously on (red) and indication "ALARM IMMO B0005" on the
display
Troubleshooting
•
Check the sensor connector on the wiring harness and the instrument panel connector.
Check that the antenna is connected, if OK remove it and check the continuity of the antenna
between the PIN of the connector (resistance between 10 - 100 Ohm), if not OK replace the
sensor; if OK reconnect the connector to the antenna and check from the wiring harness
side that there is continuity between the two PIN (resistance between 10-100 Ohm), if not
OK restore the wiring harness; if OK check continuity between the two PIN 2 and 3 of the
instrument panel, if not OK replace the instrument panel.
Error code B0006 (ALARM IMMO B0006)
Error cause
•
Occurs when a fault in the instrument panel has been detected
Identification
•
General alarm warning continuously on (red) and indication "ALARM IMMO B0006"
Electrical system
ELE SYS - 105