MOTO GUZZI V100 E5 2023 Service Station Manual page 85

V100 E5
ONLY FILL TO THE "MAX" LEVEL AFTER FITTING NEW
BRAKE PADS. DO NOT FILL TO THE "MAX" LEVEL WITH
WORN PADS, AS THIS WILL CAUSE FLUID TO ESCAPE
WHEN REPLACING BRAKE PADS.
CHECK BRAKING EFFICIENCY.
IF THE DEAD ZONE OF THE BRAKE PEDAL OR BRAKE
LEVER IS TOO LONG, OR IN CASE OF FLUID LOSS, IT
MAY BE NECESSARY TO BLEED THE AIR TRAPPED IN
THE SYSTEM.
Clutch system
Regolazione leva frizione
Perform the clutch adjustment when the engine
stops or the vehicle tends to drive forward with the
clutch lever actuated and the gear engaged, or if
the clutch "slips", causing the acceleration to delay
in relation to the number of engine revolutions. It
is possible to adjust the distance between the end
of the lever (1) and the grip (2), turning the adjuster
(3).
•
Push the control lever (1) forwards and
turn the adjuster (3) until the lever (1)
is at the desired distance.
•
Turning the adjuster clockwise moves
the lever (1) away from the handle (2).
In the event that the adjustment of the lever is not
sufficient, check that there is no air in the hydraulic
circuit or loss along the same; refer to the section
"braking system" for more information.
Headlight adjustment
NOTE
IN COMPLIANCE WITH LOCAL LEGISLATION, SPECIFIC PROCEDURES MUST BE FOLLOWED
WHEN ALIGNING THE LIGHTS.
Maintenance
MAIN - 85