MOTO GUZZI V100 E5 2023 Service Station Manual page 197

V100 E5
stanchion
Check that the sliding surface is not scratched or scored.
Any scoring can be removed by sanding with damp sandpaper (grain 1).
If the scratches are deep, replace the stanchion .
Using a dial gauge, check than any bending of the stanchion is below the limit value.
If it is over the limit, replace the stanchion .
CAUTION
A BENT STANCHION SHOULD NEVER BE STRAIGHTENED SINCE ITS STRUCTURE WOULD BE
WEAKENED MAKING THE VEHICLE DANGEROUS TO USE.
Characteristic
Bending limit:
0.2 mm (0.00787 in)
Sleeve
Check for damage and/or cracks; if it is damaged, replace it.
Spring
Check for damage and/or cracks; If it is damaged, replace it.
Reassembling the fork
V100 Mandello
NOTE
THE FOLLOWING OPERATIONS REFER TO THE KAYABA FORKS WITH MECHANICAL AD-
JUSTMENTS.
CAUTION
THE STEMS ARE NOT THE SAME, THEREFORE THEY REQUIRE SEPARATE MOUNTING PRO-
CEDURES.
THE FOLLOWING OPERATIONS APPLY WHEN
MOUNTING THE RIGHT HAND STEM.
•
Observing the indicated sequence, ex-
tract and remove the dust guard (1),
the seeger ring (2), the oil seal (3), the
ring (4), the guide bushing (5) and the
slider bushing (6).
Suspensions
SUSP - 197