MOTO GUZZI V100 E5 2023 Service Station Manual page 135

V100 E5
Key
(1) PURGE valve
1. Track power supply 1
2. Track 1 ground
3. Track 1 signal
4. Track power supply 2
5. Track 2 ground
6. Track 2 signal
(2) 11MP ECU
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING,
CAREFULLY READ THE GENERAL TROUBLESHOOTING
CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGIN-
NING OF THE CHECK AND CONTROL SECTION IN THE
ELECTRICAL SYSTEM CHAPTER.
Intake pressure sensor
PRESSURE/Tmap AIR TEMPERATURE SEN-
SOR
Function
The Tmap sensor calculates the pressure and
temperature of the engine intake air and sends this
data to the control unit, which consequently ad-
justs the ignition timing and the correct amount of
fuel to achieve the correct stoichiometric ratio.
Level in electrical circuit diagram:
intake air pressure sensor
Position:
•
on the vehicle: on the throttle bodies,
one for each throttle body.
•
connector: on the sensor.
Key:
(1) RH cylinder Tmap:
1. Earth.
2. Intake air temperature signal.
3. Pressure sensor power supply.
4. Intake air pressure signal.
(2) LH cylinder Tmap:
Electrical system
ELE SYS - 135