MOTO GUZZI V100 E5 2023 Service Station Manual page 250

Chassis
•
Loosen the screw (4) of the swingarm
pivot.
During refitting, tighten the screw of the swingarm
pivot to the prescribed torque.
Locking torques (N*m)
Swingarm pivot screw
•
Unscrew the swingarm pivot (5).
During refitting, tighten the pin of the swingarm to
the prescribed torque.
Locking torques (N*m)
Swingarm pin
65 ± 9.5 Nm (47.94 ± 7.01 lb ft)
•
Support the swingarm and remove the
pin (5).
•
Remove the swingarm from the vehi-
cle, sliding the cardan shaft (6) inside.
Cardan shaft
CHAS - 250
28 ± 4 Nm (20.65 ± 2.95 lbf ft)
V100 E5