V100 E5
Removing
•
First remove the rear wheel, the bevel
gear and the swingarm.
•
Using a suitable tool, apply force on the
gearbox output shaft (1) in order to re-
lease the cardan shaft (2) from the
gearbox output shaft spline.
Checking
Carefully check:
The splines (1) of the cardan shaft must be intact,
without grainings or dents.
Check that the joint (2) is not hardened or exces-
sively loose, in which case the complete cardan
shaft must be replaced.
In the figure are shown two worn toothing profiles:
•
Profile (3) shows acceptable wear, the
cardan shaft should not be replaced.
•
Profile (4) shows unacceptable wear,
the cardan shaft must be replaced.
Chassis
CHAS - 251