V100 E5
•
Cut the plastic clamp shown in the fig-
ure, on both sides of the vehicle.
•
Remove the 4 cable gland clips and re-
move the side covers of the radiator.
•
Repeat on the opposite side.
•
Pass the wiring harnesses through the
frame to prevent them from getting
damaged during the engine removal.
On both sides.
•
Unscrew the three fixing screws (8) of
the head support (9).
During refitting, tighten the fixing screws to the
prescribed torque.
Locking torques (N*m)
Head support fixing screw
lb ft)
50 ± 7.5 Nm (36.88 ± 5.53
Engine from vehicle
ENG VE - 159