Braking system
•
Insert an 8 mm spanner on the bleed-
ing valve and attach a rubber hose (4)
to the valve connection.
•
Connect the other end of the rubber
hose to a suitably sized container.
•
FULLY press and release the front
brake lever quickly for several times.
•
After four / five complete cycles, hold
the front brake lever fully depressed.
•
Keeping the front brake lever de-
pressed, open the brake calliper bleed-
ing valve. This will drain the brake fluid
inside the container.
•
Close the bleeding valve BEFORE re-
leasing the front brake lever.
•
Repeat the "braking" and bleeding cy-
cles until the fluid coming out of the
calliper is free of air bubbles.
•
Test the lever stroke and ensure that
the pressure does not feel "spongy". In
this case, air is still present in the cir-
cuit, which must be removed by re-
peating the above steps.
•
After completing operations, tighten
the bleeding valve and remove the rub-
ber hose and spanner.
•
Replace the rubber cap.
BRAK SYS - 304
V100 E5