MOTO GUZZI V100 E5 2023 Service Station Manual page 103

V100 E5
Electrical system
If there is an immobilizer failure at ignition, the in-
strument cluster requests you to enter a user code.
If the code is entered correctly, the instrument
cluster signals the failure by displaying the word
SERVICE and the red general warning light turns
on.
Once the code has been correctly entered, the er-
ror will be displayed on the screen, and you can
still start the motorcycle.
CAUTION
PRESSING OR MOVING ANY CONTROL ON THE LEFT
SWITCH CLUSTER, IT IS POSSIBLE TO REMOVE THE ER-
ROR NOTIFICATION SCREEN, BUT THE SCREEN WILL BE
VISIBLE AGAIN AFTER ABOUT 10 SECONDS.
Change user code (Change user code)
This function may be used to modify the existing
code (you must be in possession of the code itself
in order to do this). The user code enables engine
start even in the event of an immobiliser system
fault. The user code is set by default as five zeros
(00000) on a new vehicle, and the message "IN-
SERT CODE" is shown on the display for ten
seconds.
This function allows you to change the code itself
and remove this message.
On the value to the leftmost of the display a value
from 0 to 9 will be shown (which can be modified
by moving the MODE selector upward or down-
ward). Press the centre of the "MODE" selector
briefly to confirm the selection. Repeat the opera-
tion for all the digits. Once the code is confirmed,
the new code is shown steadily on the display to
let the user verify that the code has been entered
correctly. Turn the ignition off and then on again to
unlock the instrument cluster. The last code set
may be modified again in future. Access the setting
mode again, enter the last user code used (OLD
CODE), then enter a new user code (NEW CODE)
as described previously.
ELE SYS - 103