MOTO GUZZI V100 E5 2023 Service Station Manual page 65

V100 E5
Maintenance
Using a special syringe, fill in with new oil through
the filler cap.
CAUTION
DO NOT ADD ADDITIVES OR OTHER SUBSTANCES TO
THE FLUID. WHEN USING A FUNNEL OR ANY OTHER EL-
EMENT, MAKE SURE IT IS PERFECTLY CLEAN.
Recommended products
75W-140 lubricant for gearboxes and transmis-
sions Synthetic lubricant for gearboxes and
transmissions
SAE 75W-140 - API GL5
Characteristic
Bevel gear set oil
250 cm³ (15.26 cu in)
Bevel gear oil (in case of replacement)
225 cc (13.73 cu in) MAX
Screw and tighten the filler cap with its washer to
the prescribed torque.
NOTE
DURING REPLACEMENT, USE A NEW SEALING WASHER.
CAUTION
IF IT IS NECESSARY TO INSTALL A NEW TRANSMISSION
GEARBOX, PAY SPECIAL ATTENTION TO THE PROCE-
DURE BELOW
Locking torques (N*m)
Oil load cap
25 Nm (18.43 lb ft)
Since they are already run-in at the factory, the
complete transmission boxes coming from the
Spare parts department contain a minimum resid-
ual oil quantity and therefore after installing them
on the vehicle, the following procedure must be
performed:
• O pen the filler plug and drain any residual oil from
the lower drain plug leaving it to drip for at least 5
minutes.
• R efit and tighten the lower drain plug and fill with
oil from the filler cap.
• R efit and tighten the filler cap.
• A ssemble the breather cap. If the gearbox arrived
with the breather plug already assembled, remove
MAIN - 65