V100 E5
•
Before positioning the cap, adjust the
hydraulic regulator screw so that the
internal distance is as close as possi-
ble to 13 mm (0.51 in).
•
Screw the cap (17) onto the plunger as
far as it will go.
CAUTION
CHECK THE O-RING PRESENT ON THE FILLING CAP AND
REPLACE IF DAMAGED.
•
Ensure that the cap cannot rotate, and
then tighten the nut.
•
Tighten the cap on the sleeve, applying
the pre-defined torque.
Suspensions
SUSP - 201