V100 E5
•
Repeat the operation for the remaining
valves.
If the valve clearance is not within the tolerance
range, adjust the valve clearance as shown below.
•
Turn the rear wheel and bring the right-
hand piston to TDC and in compres-
sion (the lobes of the camshafts must
face upwards and diverge from each
other, as shown in the figure).
•
Repeat the valve clearance control op-
erations on the right head.
If the valve clearance is not within the tolerance
range, adjust the valve clearance as shown below.
VALVE CLEARANCE ADJUSTMENT
RIGHT HEAD
•
Preventively remove: radiator, timing
cover, spark plug valve covers.
•
Turn the engine counter-clockwise and
bring the RH piston to Top Dead Cen-
tre.
NOTE
THE HOLE ON THE PINION MARKED "PMS DX" MUST BE
ALIGNED WITH THE HOLE ON THE CRANKCASE.
•
Insert the centring pin in the crankshaft
pinion, making sure to intercept the
holes of the pinion and of the crank-
case.
Specific tooling
020851Y Camshaft timing pin
Maintenance
MAIN - 75