MOTO GUZZI V100 E5 2023 Service Station Manual page 181

V100 E5
•
Support the clutch pump and unscrew
the two screws (7) of the fixing U-bolt
(8).
•
Remove the clutch pump from the han-
dlebar and place it on the tank, taking
care not to tension the pipe or damage
the bodywork.
•
Unscrew the four fixing screws (9) of
the handlebar.
During refitting, first tighten the front fixing screws
and then the rear, all to the prescribed torque.
Locking torques (N*m)
Handlebar fixing screw
•
Remove the U-bolt (10) of the handle-
bar, then remove the handlebar itself
from the vehicle.
CAUTION
ALWAYS REPLACE A DAMAGED AND/OR BENT HANDLE-
BAR AS ITS STRUCTURAL STRENGTH IS COMPRO-
MISED. NEVER ATTEMPT TO READJUST A BENT HAN-
DLEBAR, EVEN IF IT IS ONLY SLIGHTLY BENT.
25 Nm (14.44 lbf ft)
Suspensions
SUSP - 181