MOTO GUZZI V100 E5 2023 Service Station Manual page 84

Maintenance
SAE J 1703; FMVSS 116; ISO 4925; CUNA NC 956 DOT4
Front braking system
•
Use a short Philips screwdriver, un-
screw the screws (1) of the front brak-
ing system fluid tank (2).
•
Lift and remove the cover (3) and
screws (1) as well.
•
Remove the gasket (4).
•
Top up the reservoir (2) with recom-
mended brake fluid to above the mini-
mum level marking "MIN".
CAUTION
ONLY FILL TO THE "MAX" LEVEL AFTER FITTING NEW
BRAKE PADS. DO NOT FILL TO THE "MAX" LEVEL WITH
WORN PADS, AS THIS WILL CAUSE FLUID TO ESCAPE
WHEN REPLACING BRAKE PADS.
CHECK BRAKING EFFICIENCY.
IF THE DEAD ZONE OF THE BRAKE PEDAL OR BRAKE
LEVER IS TOO LONG, OR IN CASE OF FLUID LOSS, IT
MAY BE NECESSARY TO BLEED THE AIR TRAPPED IN
THE SYSTEM.
Rear braking system
•
Unscrew the cap (5) and remove to-
gether with the gasket (6).
•
Top up the reservoir (7) with recom-
mended brake fluid to above the mini-
mum level marking "MIN".
CAUTION
MAIN - 84
V100 E5