MOTO GUZZI V100 E5 2023 Service Station Manual page 196

Suspensions
PROCEED WITH EXTREME CAUTION IN ORDER TO PREVENT FOREIGN BODIES FROM EN-
TERING THE SLEEVE OR THE WHEEL HOLDER SHAFT. DO NOT REUSE THE OIL THAT WAS
DRAINED EARLIER
Checking the components
V100 Mandello
NOTE
THE FOLLOWING OPERATIONS REFER TO THE KAYABA FORKS WITH MECHANICAL AD-
JUSTMENTS.
stanchion
Check that the sliding surface is not scratched or scored.
Any scoring can be removed by sanding with damp sandpaper (grain 1).
If the scratches are deep, replace the stanchion .
Using a dial gauge, check than any bending of the stanchion is below the limit value.
If it is over the limit, replace the stanchion .
CAUTION
A BENT STANCHION SHOULD NEVER BE STRAIGHTENED SINCE ITS STRUCTURE WOULD BE
WEAKENED MAKING THE VEHICLE DANGEROUS TO USE.
Characteristic
Bending limit:
0.2 mm (0.00787 in)
Sleeve
Check for damage and/or cracks; if it is damaged, replace it.
Spring
Check for damage and/or cracks; If it is damaged, replace it.
Check the condition of the following components:
•
slider bushing;
•
guide bushing;
•
plunger.
If there is evidence of excessive wear or damage, replace the component concerned.
CAUTION
REMOVE ANY IMPURITIES FROM THE BUSHINGS, BEING CAREFUL NOT TO SCRATCH THEIR
SURFACES.
Replace the following components with new ones:
•
Oil seal.
•
Dust guard.
•
- O-ring on the cap.
V100 Mandello S
NOTE
THE FOLLOWING OPERATIONS ARE FOR OHLINS FORKS WITH ELECTRONIC ADJUSTMENTS.
SUSP - 196
V100 E5