MOTO GUZZI V100 E5 2023 Service Station Manual page 117

V100 E5
Control unit
ENGINE TONE WHEEL PROGRAMMING PRO-
CEDURE
•
Using the PADS diagnostic tool, per-
form the "Reset wheel tooth values";
•
Bring the engine to a temperature
above 80°;
Then proceed as described:
•
In neutral position, with the side stand
extended/open and with the vehicle
absolutely immobile, quickly bring the
engine above 7000 RPM (it is not nec-
essary to stay there, it is sufficient to
exceed it);
•
Close the throttle completely and wait
for the engine to go down to idle speed;
•
Repeat this procedure three times.
The success of the procedure is confirmed by the
immediate turning off of the MIL light (in the pres-
ence of other errors the MIL light may remain on
but in any case stops flashing).
Switch off the panel and wait for at least one mi-
nute (Power Latch).
CAUTION
DURING THE ENGINE TONE WHEEL PROGRAMMING
PROCEDURE, THE VEHICLE'S SPEED MUST ALWAYS BE
0 km/h.
IN CERTAIN CASES, EVEN SMALL VIBRATIONS GENER-
ATED BY THE ENGINE (WITH THE ENGINE IN NEUTRAL
POSITION AND THE SIDE STAND EXTENDED/OPEN, THE
INSTRUMENT PANEL DOES NOT DETECT THE VEHICLE'S
SPEED), MAY CAUSE THE PROCEDURE TO FAIL, WHICH
Electrical system
ELE SYS - 117