MOTO GUZZI V100 E5 2023 Service Station Manual page 290

Braking system
•
Remove the two rear brake calliper fix-
ing screws (1).
During refitting, tighten the fixing screws to the
prescribed torque.
NOTE
TO REMOVE THE BRAKE CALLIPER, IS NOT NECESSARY
TO REMOVE THE REAR WHEEL.
Locking torques (N*m)
Brake calliper fixing screw
lbf ft)
•
Remove the rear brake calliper from
the vehicle.
NOTE
TO REMOVE THE BRAKE CALLIPER, IS NOT NECESSARY
TO REMOVE THE REAR WHEEL.
Installing
•
Completely insert the piston inside the
calliper, so as to widen the brake pads.
•
Install the brake calliper on the vehicle,
inserting the brake disc inside.
NOTE
FOR THE INSTALLATION OF THE BRAKE CALLIPER, IT IS
NOT NECESSARY TO REMOVE THE REAR WHEEL.
•
Install the two fixing screws (1) and
tighten them to the specified torque.
NOTE
FOR THE INSTALLATION OF THE BRAKE CALLIPER, IT IS
NOT NECESSARY TO REMOVE THE REAR WHEEL.
Locking torques (N*m)
Brake calliper fixing screw
lbf ft)
BRAK SYS - 290
50 ± 5 Nm (36.88 ± 3.69
50 ± 5 Nm (36.88 ± 3.69
V100 E5