MOTO GUZZI V100 E5 2023 Service Station Manual page 231

V100 E5
FOR MAINTENANCE/REPAIR WORK AND WHERE THERE
IS A NEED TO LIFT THE VEHICLE WHEELS OFF THE
GROUND, INSTALL A WORKSHOP STAND AT THE REAR
WHEEL AND PLACE A PANTOGRAPH JACK UNDER THE
OIL SUMP. PLACE A GUARD BETWEEN THE JACK AND
THE OIL SUMP TO PREVENT DAMAGE TO THE OIL SUMP.
FINALLY, MAKE SURE THAT THE VEHICLE IS STABLE
BEFORE CARRYING OUT ANY OPERATION.
Wheels
REPLACEMENT PROCEDURE OF THE TPMS SENSOR - VALVE
Remove the relevant wheel from the vehicle.
NOTE
The following procedure applies to the rear tyre, but is also applicable to the front tyre.
Remove the tyre using a tyre changer.
CAUTION
The bead breaking of the tyre must take place at a distance
of at least 90° from the inflation valve.
CAUTION
The positioning of the levers for the removal of the tyre
must be at a distance of at least 10 cm (3.93 in) from the
inflation valve.
Chassis
CHAS - 231