MOTO GUZZI V100 E5 2023 Service Station Manual page 329

V100 E5
Removing the clutch slave cylinder
•
Remove the union screw (1) and re-
trieve the sealing washers (2).
DURING REFITTING, USE NEW SEALING WASHERS.
•
Remove the two fixing screws (3) of the
rear shock absorber preload adjuster.
During refitting, tighten the fixing screws to the
prescribed torque.
Locking torques (N*m)
Preload adjuster fixing screw
lb ft)
•
Remove the three fixing screws (4).
•
Remove the clutch cylinder (5) from the
clutch housing.
AFTER REFITTING, BLEED THE HYDRAULIC CIRCUIT OF
THE CLUTCH.
10 ± 2 Nm (7.38 ± 1.48
Clutch system
CLU SYS - 329