Central Chain Lubrication System - Krone Fortima F 1250 Original Operating Instructions

Pos: 62.43.1 /Überschriften/Überschriften 2/U-Z/Zentrale Kettenschmierung @ 33\mod_1254819776816_78.docx @ 319945 @ 2 @ 1
12.2

Central chain lubrication system

Pos: 62.43.2 /BA/Einstellungen/Rundballenpresse/Zentrale Kettenschmierung @ 33\mod_1254819918129_78.docx @ 319966 @ @ 1
Fig. 228
The central chain lubrication system is attached to the left-hand side of the machine behind the
front guard.
Each time the drive shaft makes a rotation, oil is forced out of the tank (1) via the pump (2) and
the lubrication manifolds attached to the left-hand and right-hand side of the machine, and onto
the brushes on the drive chains.
Different nozzles are built into the lubrication manifolds for each lubrication point.
The delivery rate can be adjusted by means of the eccentric cam (3) on the drive roller.
2
Fig. 229
• Loosen the screws (2).
• Rotate the eccentric cam disc (1).
• Retighten the screws (2).
Pos: 62.43.3 /BA/Einstellungen/Rundballenpresse/Exzenterscheiben @ 55\mod_1292236108625_78.docx @ 518264 @ @ 1
Position of excenter discs:
• Excenter disc (1) on marking (1) correspondents little oil
• Excenter disc (1) on marking (8) correspondents much oil
Check dimension 128 mm and adjust if necessary.
Note
The amount of oil has to be adjusted to the outside temperature and the harvesting conditions.
The chains have to be lubricated sufficiently.
Pos: 62.43.4 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
1
2
3
RBV05150
128 mm
1
VP-2-001
Settings
269