Pos: 56.22 /BA/Fahren und Transport/Rundballenpresse/Bild Abstellstütze runter @ 32\mod_1253617125109_78.docx @ 315487 @ 3 @ 1
10.2.2
Lowering the parking support
1
2
3
Fig. 159
Pos: 56.23 /BA/Fahren und Transport/Rundballenpresse/Abstellstütze positionieren @ 32\mod_1253617584078_78.docx @ 315512 @ @ 1
•
Remove stake bolt (2), bring the support pipe out of the parking support (1) and then secure
again with the stake bolt (2).
•
Crank the support plate (3) tightly onto the ground until pressure on the drawbar has been
relieved.
Pos: 56.24 /Überschriften/Überschriften 3/F-J/Gelenkwelle vom Schlepper trennen @ 32\mod_1253619549515_78.docx @ 315616 @ 3 @ 1
10.2.3
Disconnecting the PTO shaft from the tractor
Pos: 56.25 /BA/Erstinbetriebnahme/Rundballenpresse/Gelenkwelle/Bild Gelenkwelle ablegen @ 32\mod_1253534197361_78.docx @ 314306 @ @ 1
Fig. 160
Pos: 56.26 /BA/Fahren und Transport/Rundballenpresse/Gelenkwelle abziehen @ 32\mod_1253618661515_78.docx @ 315541 @ @ 1
•
Disconnect the PTO shaft (1) on the tractor side.
Pos: 56.27 /BA/Erstinbetriebnahme/Rundballenpresse/Gelenkwelle/Gelenkwelle ablegen @ 32\mod_1253534329111_78.docx @ 314331 @ @ 1
•
Place the PTO shaft (1) inside the PTO shaft support (2).
Pos: 56.28 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
CPB00090
2
1
RBV02240
Driving and Transport
205